Table saw caddy

The design parameters I’m using for “The Thula” mandolin necessitated a table saw caddy.

The issue was that I needed a tool to allow for accurate cuts on my neck block since the nature of this adaptation is to use a M & T neck joint. A typical mandolin uses a dovetail joint at 5.5 […]

Anatomy of a new design

The next mandolin is underway!

This will be a special project because the name of this instrument will be “The Thula.” Thula was my grandmother’s name on my dad’s side of the family, she was an accomplished violinist and her story is remarkable. As each step is completed on this prototype I’ll post some pictures of her and of my dad’s […]